|
|
Questions or problems Have a question or problem about something you can't find in the Help/Users Guide? Ask it here! |
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
Re: NC 2.6 aborts if Exit after loading a Template file
Hi again Sherry,
I should have tried a bit further... but just to report that the crash happens as well if I try to Save any work done that was started by selecting a Template (via File>New as described above). I did this (to see if would correct the problem):- Copied ...\Templates folder to some other place Re-installed NC2.6.3 from the link you supplied Copied the Template folder back to correct place The problem persists though. The only way I can use NC now is to open a Template via File>Open as can't use File New at all. I seem to remember there was something like this happened a long time ago (?). Appreciate your help. regard -jss |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Version 2.6 of all Notation Software products now available | Sherry C | Announcements | 0 | 06-15-2010 03:13 AM |