Quote:
Originally Posted by Sherry C
Howdy Ian,
I just tried the following steps to successfully create a 40 measure piano score and then add another 16 measures to it:
Composer properly added 16 measures to the score without adding any extra staves. The steps above are minimal - I did no editing of the score at all. Was there any editing that you had done prior to adding the measures, or did you perhaps earlier add new staves, but then decide you didn't need/want them, or....?
Any additional information (or a copy of the "before" file) should help us figure this out 
ttfn,
Sherry |
Thanks Sherry,
I did what you suggested and of course it worked fine.
Some background... I scanned a piano score sheet and converted it to a midi file which I then imported to NC. I then converted it to a piano grand staff in NC by adding braces to it.
Maybe this is where the problem arises. I haven't added or subtracted any staves previously as it's a 40 bar piece and that's it. However as the program doesn't seem to recognize D.C. da Fine, etc I decided to add a copy of the first 16 bars onto the end.
This brings me to another thing - I thought I would copy and paste the whole thing into a new piano score by region selecting and copying, a section at at a time and then doing the add measures thing. But would you believe it, the treble part gets copied but not the bass even though I had it selected.
Anyway, I don't have any before file, just the one I've been working on. So I've attached that along with the original midi file.
Many thanks for your help,
Ian