Hi,
Quote:
Originally Posted by dai phan
Hi,
I tried to set up GPO with NC as instructed but I cannot get any sounds to play back. The NC did recorded the data but no sound when played back. Please advise. Thanks Dai
|
If you're using LoopBe, make sure it is not muted. Sometimes a MIDI file will contain spurious MIDI controller events, or if both the IN and OUT are "on" for Composer, it can cause a feedback loop in LoopBe which will trigger the Mute to "on".
If the LoopBe Mute was "on", check in Composer's Setup->MIDI Device Configuration -> Internal 1 (or whatever LoopBe is called in your setup) and see if it is set as both In and Out. If it is set for both, then click on Ports -> Select Ports, and UNCHECK it in the "IN" side.
Hopefully the above tips will work for you. If not, you may want to review the tutorial videos on "
Virtual MIDI Cable Installation" and "
Getting Started With Garritan Libraries". And you can always ask questions here
Enjoy!
Sherry